2025 Hyundai Santa Fe Tire Size
The 2025 Hyundai Santa Fe came with 235/60R18, 245/60R18, 255/45R20 or 245/45R21 tires, depending on the trim and wheel size. Recommended cold pressure: 35 to 36 psi depending on size.
Not sure which one you have? Read the size off your tire's sidewall, or check the label on the driver's door jamb. How to read a tire size.
✓ From the manual ·2025 Hyundai Santa Fe owner's manual, p. 649
Factory tire sizes
- Width
- 235 mm (9.3 in)
- Wheel
- 18 in · 7.5J x 18
- Overall diameter
- 29.1 in
- Cold pressure
- 35 psi
- Width
- 245 mm (9.6 in)
- Wheel
- 18 in · 7.5J x 18
- Overall diameter
- 29.6 in
- Cold pressure
- 35 psi
- Width
- 255 mm (10 in)
- Wheel
- 20 in · 8.5J x 20
- Overall diameter
- 29 in
- Cold pressure
- 36 psi
- Width
- 245 mm (9.6 in)
- Wheel
- 21 in · 8.5J x 21
- Overall diameter
- 29.7 in
- Cold pressure
- 36 psi
Spare tire
- Width
- 135 mm (5.3 in)
- Wheel
- 17 in · 4.0B x 17
- Overall diameter
- 26.6 in
- Cold pressure
- 60 psi
A temporary spare is for short trips at reduced speed, usually no faster than 50 mph. Follow the limit printed on the spare and in your manual, and replace the flat as soon as you can.
Questions
What size tires does a 2025 Hyundai Santa Fe have?
The 2025 Hyundai Santa Fe came with 235/60R18, 245/60R18, 255/45R20 or 245/45R21 tires, depending on the trim and wheel size.
Which size is on my 2025 Hyundai Santa Fe?
Look at the sidewall of one of your tires: the size is the code that looks like 235/60R18. The label on the driver's door jamb also lists the original size and pressure for your exact trim.
What tire pressure does a 2025 Hyundai Santa Fe need?
The manual gives 35 to 36 psi depending on size, measured with the tires cold. Check it before driving, and go by the door-jamb label if it differs, because that is set for your exact car.
Can I fit a different tire size on my 2025 Hyundai Santa Fe?
Stick to a factory size for your wheel unless a tire shop confirms the swap. A different overall diameter changes speedometer readings and can upset ABS and stability control, and the load index must be at least the original.