2013 Toyota Sequoia Tire Size
The 2013 Toyota Sequoia came with 275/65R18 or 275/55R20 tires, depending on the trim and wheel size. Recommended cold pressure: 30 to 33 psi front, 33 psi rear depending on size.
Not sure which one you have? Read the size off your tire's sidewall, or check the label on the driver's door jamb. How to read a tire size.
✓ From the manual ·2013 Toyota Sequoia owner's manual, p. 687
Factory tire sizes
- Width
- 275 mm (10.8 in)
- Wheel
- 18 in · 18 x 8J
- Overall diameter
- 32.1 in
- Cold pressure
- 33 psi
- Load index
- 114 (2,601 lb)
- Speed rating
- T (up to 118 mph)
- Width
- 275 mm (10.8 in)
- Wheel
- 20 in · 20 x 8J
- Overall diameter
- 31.9 in
- Cold pressure
- 30 psi front, 33 psi rear
- Load index
- 111 (2,403 lb)
- Speed rating
- H (up to 130 mph)
Spare tire
- Width
- 255 mm (10 in)
- Wheel
- 18 in
- Overall diameter
- 32.1 in
- Cold pressure
- 33 psi
- Load index
- 112 (2,469 lb)
- Speed rating
- T (up to 118 mph)
A temporary spare is for short trips at reduced speed, usually no faster than 50 mph. Follow the limit printed on the spare and in your manual, and replace the flat as soon as you can.
Questions
What size tires does a 2013 Toyota Sequoia have?
The 2013 Toyota Sequoia came with 275/65R18 or 275/55R20 tires, depending on the trim and wheel size.
Which size is on my 2013 Toyota Sequoia?
Look at the sidewall of one of your tires: the size is the code that looks like 275/65R18. The label on the driver's door jamb also lists the original size and pressure for your exact trim.
What tire pressure does a 2013 Toyota Sequoia need?
The manual gives 30 to 33 psi front, 33 psi rear depending on size, measured with the tires cold. Check it before driving, and go by the door-jamb label if it differs, because that is set for your exact car.
Can I fit a different tire size on my 2013 Toyota Sequoia?
Stick to a factory size for your wheel unless a tire shop confirms the swap. A different overall diameter changes speedometer readings and can upset ABS and stability control, and the load index must be at least the original.